Wittus H530 User Manual

Tested and Liste d by: OMNI-Test Laboratories, Inc. C US Portland Oregon USA - Please read this manual ca

Lighting the stove 1. Make sure the air vent is in the fully open position (move the handle to the left as shown by the wide end of a triangle). 2. A

5. TROUBLESHOOTING Combustion problems can arise if the combustion conditions are not optimal. This can be corrected by following the advice given be

Version: 10/09 Page 12 6. MAINTENANCE Gaskets and vermiculite panels are parts which need to be replaced from time to time – depending on how much

Version: 10/09 Page 13 soil or otherwise locally dispersed, they should be retained in the closed container until all cinders have thoroughly cooled

Version: 10/09 Page 14

TABLE OF CONTENTS 1. INTRODUCTION ...2 Safety and Environmental Testing... 3 Features and Items Inclu

Version: 10/09 Page 3 Safety and Environmental Testing The H530 Inserts have been tested by OMNI-Test Laboratories, Inc. of Portland, Oregon and are

Specifications UL 1777 Listed chimney liner (with a 6” (15cm) diameter) up through the block off plate of an existing masonry chimney, a zero-clea

Set up and Installation To minimize the weight of the insert before installation, it is possible and simple to dismount the door by lifting it up and

Chimney The H530 insert must be installed using a code-approved masonry chimney with a 6 ” (15cm) diameter flue liner, a zero-clearance chimney, or a

To fit the insert into the zero-clearance firebox, the following items may be removed: damper, ember catches, fire grate, doors, and viewing screen o

conditions that produce an extra-strong draft in the chimney. Never fill the stove completely with wood. It is better to heat a stove up slowly. This

Version: 10/09 Page 9 Fuel Recently-felled wood contains 60-70% water and must therefore be seasoned before it can be used in a wood burning stove.